U-Boot 1.3.2-g02c22ce0-dirty (May 14 2008 - 13:13:06)

U-Boot code: 00000000 -> 0000e820  data: 00014098 -> 0001a788
SDRAM: 64 MB at address 0x10000000
Testing SDRAM...OK
malloc: Using memory from 0x13fa5000 to 0x13fe5000
DMA: Using memory from 0x13fa1000 to 0x13fa5000
Flash:  8 MB at address 0x00000000
DRAM Configuration:
Bank #0: 10000000 64 MB
In:    serial
Out:   serial
Err:   serial
Net:   macb0
Press SPACE to abort autoboot in 3 seconds
partition changed to nor0,2
### JFFS2 loading '/boot/uImage' to 0x10400000
Scanning JFFS2 FS: ......... done.
### JFFS2 load complete: 1330615 bytes loaded to 0x10400000
## Booting image at 10400000 ...
   Image Name:   Linux-2.6.24-icnova_base1
   Image Type:   AVR32 Linux Kernel Image (gzip compressed)
   Data Size:    1330551 Bytes =  1.3 MB
   Load Address: 10000000
   Entry Point:  90000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK

Starting kernel at 90000000 (params at 13fa5008)...

Linux version 2.6.24-icnova_base1 (benjamin@marvin) (gcc version 4.0.4-atmel.0.99.0) #62 Mon Jun 23 10:24:59 CEST 2008
CPU: AT32AP700x chip revision C
CPU: AP7 [01] core revision 0 (AVR32B arch revision 1)
CPU: MMU configuration: Shared TLB
CPU: features: dsp simd ocd perfctr java
CPU: Running at 140.000 MHz
Physical memory:
  10000000-13ffffff
Reserved memory:
  10000000-101738a9: Kernel code
  101738aa-10231307: Kernel data
Exception vectors start at 90010000
CPU: Paging enabled
Node 0: start_pfn = 0x10000, low = 0x14000
Node 0: mem_map starts at 90234000
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
Kernel command line: root=1F02 rootfstype=jffs2 mtdparts=physmap-flash.0:128k(boot)ro,64k(env)ro,-(root)
PID hash table entries: 256 (order: 8, 1024 bytes)
timer: AT32AP system timer/counter at 0xfff00c00 irq 22
Console: colour dummy device 80x25
console [tty0] enabled
console [ttyS0] enabled
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 62652k/62716k available (1422k kernel code, 2820k reserved, 117k data, 64k init)
Calibrating delay using timer specific routine.. 280.63 BogoMIPS (lpj=561269)
Mount-cache hash table entries: 512
net_namespace: 156 bytes
NET: Registered protocol family 16
ICNova: 9 Leds
pdc pdc.0: Atmel Peripheral DMA Controller enabled
at32_eic at32_eic.0: External Interrupt Controller at 0xfff00100, IRQ 19
at32_eic at32_eic.0: Handling 4 external IRQs, starting with IRQ 64
smc smc.0: Atmel Static Memory Controller at 0xfff03400
cpufreq: AT32AP CPU frequency driver
dmac0: DesignWare DMA controller at 0xff200000 irq 2
Time: avr32 clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
audit: initializing netlink socket (disabled)
type=2000 audit(1167609600.331:1): initialized
JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler cfq registered (default)
atmel_usart.0: ttyS0 at MMIO 0xffe01000 (irq = 7) is a ATMEL_SERIAL
atmel_usart.1: ttyS1 at MMIO 0xffe00c00 (irq = 6) is a ATMEL_SERIAL
MACB_mii_bus: probed
eth0: Atmel MACB at 0xfff01800 irq 25 (00:1f:e5:00:19:99)
eth0: attached PHY driver [Davicom DM9161A] (mii_bus:phy_addr=0:00, irq=-1)
physmap platform flash device: 00800000 at 00000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
 Amd/Fujitsu Extended Query Table at 0x0041
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
mtd: scanning for physmap-flash.0
3 cmdlinepart partitions found on MTD device physmap-flash.0
Creating 3 MTD partitions on "physmap-flash.0":
0x00000000-0x00020000 : "boot"
ftl_cs: FTL header not found.
0x00020000-0x00030000 : "env"
ftl_cs: FTL header not found.
0x00030000-0x00800000 : "root"
ftl_cs: FTL header not found.
block2mtd: version $Revision: 1.30 $
atmel_usba_udc atmel_usba_udc.0: MMIO registers at 0xfff03000 mapped at fff03000
atmel_usba_udc atmel_usba_udc.0: FIFO at 0xff300000 mapped at ff300000
Registered led device: pwrled:red
Registered led device: led1:green
Registered led device: led2:green
Registered led device: led3:green
Registered led device: led4:green
Registered led device: led5:green
Registered led device: led6:green
Registered led device: led7:green
Registered led device: led8:green
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 64K (90000000 - 90010000)
init started: BusyBox v1.5.0 (2008-04-24 11:31:03 CEST) multi-call binary
eth0: link up (100/Full)
created gpio0 (port0/0x0018003f) as (254:0)