E:\Documents and Settings\Nils>avrdude -p atmega32 -P com2 -c avrispv2 -vv

avrdude: Version 5.10, compiled on Jan 19 2010 at 10:45:23
         Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
         Copyright (c) 2007-2009 Joerg Wunsch

         System wide configuration file is "E:\WinAVR-20100110\bin\avrdude.conf"


         Using Port                    : com2
         Using Programmer              : avrispv2
         AVR Part                      : ATMEGA32
         Chip Erase delay              : 9000 us
         PAGEL                         : PD7
         BS2                           : PA0
         RESET disposition             : dedicated
         RETRY pulse                   : SCK
         serial program mode           : yes
         parallel program mode         : yes
         Timeout                       : 200
         StabDelay                     : 100
         CmdexeDelay                   : 25
         SyncLoops                     : 32
         ByteDelay                     : 0
         PollIndex                     : 3
         PollValue                     : 0x53
         Memory Detail                 :

                                  Block Poll               Page
      Polled
           Memory Type Mode Delay Size  Indx Paged  Size   Size #Pages MinW  Max
W   ReadBack
           ----------- ---- ----- ----- ---- ------ ------ ---- ------ ----- ---
-- ---------
           eeprom         4    10    64    0 no       1024    4      0  9000  90
00 0xff 0xff
           flash         33     6    64    0 yes     32768  128    256  4500  45
00 0xff 0xff
           lfuse          0     0     0    0 no          1    0      0  2000  20
00 0x00 0x00
           hfuse          0     0     0    0 no          1    0      0  2000  20
00 0x00 0x00
           lock           0     0     0    0 no          1    0      0  2000  20
00 0x00 0x00
           signature      0     0     0    0 no          3    0      0     0
 0 0x00 0x00
           calibration    0     0     0    0 no          4    0      0     0
 0 0x00 0x00

         Programmer Type : STK500V2
         Description     : Atmel AVR ISP V2
         Programmer Model: STK500
         Hardware Version: 10
         Firmware Version Master : 2.10
avrdude: stk500v2_command(): command failed
avrdude: stk500v2_getparm(): failed to get parameter 0x9a
         Topcard         : Unknown
         Vtarget         : 5.0 V
         SCK period      : 0.1 us
         Varef           : 5.0 V
         Oscillator      : Off

avrdude: stk500v2_command(): command failed
avrdude: stk500v2_command(): unknown status 0xc9
avrdude: stk500v2_program_enable(): cannot get connection status
avrdude: initialization failed, rc=-1
         Double check connections and try again, or use -F to override
         this check.


avrdude done.  Thank you.